Gigabyte GA-N680SLI-DQ6 скачать инструкцию по эксплуатации (Страница 3 из 72)

Языки: Русский И еще 10
  • Венгерский
  • Греческий
  • Испанский
  • Итальянский
  • Немецкий
  • Польский
  • Португальский
  • Турецкий
  • Французский
  • Чешский
Описание:Installation Guidebook
На сайте можно просмотреть полную версию документа и скачать его в формате PDF.
Страница 3 из 72
- 3 -
Remove the original I/O shield from the back of the case and replace it with the
motherboard I/O shield. Place the motherboard within the case by positioning it
into its I/O shield. Align the mounting screw holes on the motherboard with their
corresponding mounting holes on the case. Secure the motherboard in place
with screws.
Locate an expansion slot that supports your card and remove the slot cover from
the case back panel. Then insert the expansion card into the slot. Secure the
expansion card's bracket to the case back panel with a screw.
I/O Shield
Before purchasing an expansion card, check the length of the card, making
sure it can fit into your case.
Make sure that the expansion card is fully seated in its slot.
Installing the Motherboard
Installing an Expansion Card
PCI Express Graphics Card
6-1 Install your optical drives, such as DVD-ROM and CD-ROM drives.
Remove the 5.25" drive bay cover from the front of the case. Mount the optical drive
in the 5.25" drive bay and secure it with screws.
6-2 Install your IDE and SATA hard drives.
Install the hard drive into a drive bay within the case and secure it with screws.
One motherboard IDE connector can connect up to two IDE devices. Prior to installation, check the jumper
settings (master and slave) on your IDE devices.
If more than one hard drive is installed, enter system BIOS Setup to set the hard drive boot sequence.
Installing an Optical Drive
Installing a Hard Drive
Installing IDE and SATA Devices
Мануал подходит для устройств